![]() Hope this help keeping your fans less noisy! Let us know. System: laptop HP Pavilion zv6000 cpu AMD Athlon 64 processor 3500+ os Linux Mint 12 (lisa) Attempts: Install lm-sensors Run Command: sensors Output: acpitz-virtual-0 Adapter: Virtual device temp1: +50.0C (crit +82. ![]() It allows you to access information from temperature, voltage, and fan speed sensors. => Don't forget to save the configuration! Select fan output to configure, or other action:ġ) hwmon0/device/pwm2 3) Just quit 5) Show configuration Possible Solution: Reduce fan speed, set temperatures so fan does not run constant. Linux Mint - Community fancontrol utility to control the fan speed -9 9 reviews Lm-sensors is a hardware health monitoring package for Linux. => Note these values may be later ajusted to fit your needs. Is over the high temperature limit (255): 255 Is below the low temperature limit (0): 24Įnter the PWM value (45-255) to use when the temperature Enter the PWM value (0-45) to use when the temperature Reason: Topic automatically closed 6 months after creation. Pwmconfig check if there is a correlation a PWM control and a fan by trying to stop it.īy confirming to pwmconfig the fan is actually stopped this associate pwmconfig to a specific fan. Location: Kepler-438b Laptop Fan Control by WadeWayne Wed 6:45 pm Is there any way to tell my laptop's fan to turn on when my CPU's temperature hits 45C Last edited by LockBot on Wed 12:16 pm, edited 1 time in total. I'm worried that the laptop might turn off if the temperature gets critically high. My existing controls using thermald seem to keep the processor below 70 C and. ![]() Hwmon0/device/fan2_input current speed: 4326 RPM How do I start the fan manually in Linux Ask Question Asked 12 years, 3 months ago Modified 7 years, 11 months ago Viewed 45k times 13 My fan doesn't run in Linux. Ubuntu Manpage: fancontrol - automated software based fan speed regulation. Hwmon0/device/fan1_input current speed: 0 … skipping! Giving the fans some time to reach full speed… In a Terminal enter: pwmconfig and follow these stepsġ) First step: pwmconfig search for Power Waves Monitors Found the following devices: ![]() (Please note this example was a translation of an old blog article from me in french for Ubuntu Karmic Koala. I tried a lot of things to control my fan. PS, I found this link pretty informative.You may try to configure the Fan Speed based on Temperatures. So I'm going to mark this as solved for now while I monitor the GPU temps. Once I rolled back to an Nvidia driver, quiet fans and sensors-detect gave me all the fan data including for the GPU. Turned out that a Nouveau driver was loaded when I installed Mint. Long story short, the fan that was maxed out in Mint was the Nvidia GPU which I didn't see pop up in sensors-detect at all. What it did show was something that initially confused me - a nouveau device which it couldn't get any information on. After I ran pwmconfig, I was able to see some of the fans, but not the Nvidia GPU. I installed xsensors and it was able to pick up all the case fans and the CPU and they were running at relatively low speeds (it is cold in my room). I saw the arch linux thread and did install lm-sensors but sensors-detect had difficulty seeing any fans at all though it did give me the core temps. I have to lower the threshold to 300 to boot anything. That said, every time I lose power, the bios resets to alarm if the fans are lower than 600 rpm which appears to be the default but the fans are always turning much slower on a cold boot. Thank you ClixTrix - I do let bios control the fans. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |